ADVANCE CHEMICAL ENTERPRISES -- SCALE REMOVER  -- 6850-00N027962
<pre>=====================  Product Identification  =====================

Product ID:SCALE REMOVER
MSDS Date:05/20/1988
FSC:6850
NIIN:00N027962
=== Responsible Party ===
Company Name:ADVANCE CHEMICAL ENTERPRISES
Box:51531
City:JACKSONVILLE
State:FL
ZIP:32240
Country:US
Info Phone Num:904-247-1707
Emergency Phone Num:904-247-1707
CAGE:0M9X0
=== Contractor Identification ===
Company Name:ADVANCE CHEMICAL ENTERPRISES
Box:City:JACKSONVILLE
State:FL
ZIP:32240
Country:US
Phone:904-247-1707
CAGE:0M9X0

=============  Composition/Information on Ingredients  =============

Ingred Name:HYDROCHLORIC ACID
CAS:7647-01-0
RTECS #:MW4025000
OSHA PEL:5 PPM, C
ACGIH TLV:5 PPM, C
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:PHOSPHORIC ACID
CAS:7664-38-2
RTECS #:TB6300000
OSHA PEL:1 MG/M3;3 STEL
ACGIH TLV:1 MG/M3;3 STEL
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE/CHRONIC:THIS PRODUCT IS TOXIC &
    CORROSIVE TO TISSUES. CONTACT W/MATERIAL CAN CAUSE PERMANENT TISSUE
    DAMAGE, SEVERE BURNS & MAY CAUSE BLINDNESS. INGESTION MAY BE FATAL.
    FUMES ARE TOXIC & IRRITATI NG TO LUNGS & MUC MEMBRANES.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:BURNING IRRITATION OR REDNESS OF SKIN, EYES OR
    MUC MEMBRANES.
Medical Cond Aggravated by Exposure:SKIN OR BREATHING DISORDERS.

=======================  First Aid Measures  =======================

First Aid:SKIN:IMMED WASH ANY AFFECTED AREA W/H*2O FOR AT LST 15 MIN.
    FOR PRLNG IRRIT/VISIBLE TISS DMG, GET MD. EYES:IMMED WASH W/H*2O
    FOR AT LST 15 MIN. FOR VISIBLE TISS DMG, GET MD. INHAL:REMOVE
    AFFECTED INDI VIDUAL TO FRESH AIR. IF DFCLTY PERSISTS, GET MD.
    INGEST:CALL MD IMMEDIATELY .

=====================  Fire Fighting Measures  =====================

Flash Point:NONE
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
    PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

==================  Accidental Release Measures  ==================

Spill Release Procedures:DIKE SPILL W/SODA ASH, LIME/SODIUM BICARBONATE
    (BAKING SODA), THEN USE 1 OF THESE MATLS TO NEUT ACID (SINCE THIS
    WILL RELEASE LG AMT OF CO*2), PROVE ADEQ VENT & REMOVE ANY
    UNNECESSARY PERSONNEL.
Neutralizing Agent:SEE SPILL PROCEDURES.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP CONTAINER CLOSED WHEN NOT IN USE.
    KEEP OUT OF REACH OF CHILDREN. STORE IN COOL, DRY PLACE. DO NOT MIX
    THIS PRODUCT W/ANY OTHER CLEANER.
Other Precautions:DO NOT CONTAMINATE FOOD OR FEED THROUGH USE OF THIS
    PRODUCT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH/MSHA APPROVED CHEMICAL CARTRIDGE
    RESPIRATOR AS NECESSARY TO LIMIT EXPOSURE.
Ventilation:MECHANICAL (GENERAL):USE ADEQUATE VENTILATION TO MAINTAIN
    VAPORS BELOW TLV.
Protective Gloves:RUBBER OR VINYL GLOVES.
Eye Protection:CHEM WORK GOGG/FULL LENGTH FCSHLD.
Other Protective Equipment:RUBBER BOOTS & APRON AS NEEDED TO ELIM
    UNNECESSARY CONTACT W/ACID. EMERGENCY EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:WASH HANDS AFTER USING PRODUCT & BEFORE EATING
    OR SMOKING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

==================  Physical/Chemical Properties  ==================

HCC:C1
Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:2 MMHG
Vapor Density:>1
Spec Gravity:1.08 (H*2O=1)
Evaporation Rate &amp; Reference:SAME AS H*2O (BUAC=1)
Solubility in Water:MISCIBLE
Appearance and Odor:TRANSPARENT, PALE STRAW-COLORED LIQUID W/SLIGHT
    ACID ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
ALKALINE MATERIALS, METAL CONTAINERS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:HCL VAPORS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASH AWAY NEUTRALIZED MATERIAL W/LARGE EXCESS OF
    WATER, OR SCOOP UP & BURY EXCESS ABSORBED LIQUID IN APPROVED
    LANDFILL. DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL REGULATIONS
    .

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.