PIEDMONT PAINTS & PRIMERS INC -- LACQUER THINNER T-1 -- 8010-00F014062 
=====================  Product Identification  =====================

Product ID:LACQUER THINNER T-1
MSDS Date:03/13/1989
FSC:8010
NIIN:00F014062
=== Responsible Party ===
Company Name:PIEDMONT PAINTS & PRIMERS INC
Address:LIBERTY HILL RD
Box:86
City:TOCCOA
State:GA
ZIP:30577
Info Phone Num:(404) 886-1462
Emergency Phone Num:(404) 886-7239
CAGE:PIEDM
=== Contractor Identification ===
Company Name:PIEDMONT PAINTS & PRIMERS INC
Address:LIBERTY HILL RD
Box:86
City:TOCCOA
State:GA
ZIP:30577
Phone:(404) 886-1462
CAGE:PIEDM

=============  Composition/Information on Ingredients  =============

Ingred Name:VOL ORGANIC CMPD: (#/GAL): 6.76 LBS.
RTECS #:9999999VO

Ingred Name:TOLUENE  (SARA III)
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 20-50%
Other REC Limits:100 PPM
OSHA PEL:200 PPM/150 STEL
ACGIH TLV:50 PPM; 9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:LIGHT ALIPHATIC NAPHTHA, VM & P NAPHTHA
CAS:64742-89-8
Fraction by Wt: 5-20%
OSHA PEL:500 PPM
ACGIH TLV:500 PPM

Ingred Name:METHYL ALCOHOL (METHANOL)  (SARA III)
CAS:67-56-1
RTECS #:PC1400000
Fraction by Wt: 20-50%
Other REC Limits:200 PPM
OSHA PEL:S,200PPM/250STEL
ACGIH TLV:S,200PPM/250STEL; 93
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:ACETONE  (SARA III)
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 20-50%
Other REC Limits:590 MG/CUM
OSHA PEL:1000PPM
ACGIH TLV:750PPM/1000STEL;9293
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:ISOBUTYL ACETATE  (SARA III)
CAS:110-19-0
RTECS #:AI4025000
Fraction by Wt: 1-5%
Other REC Limits:150 PPM
OSHA PEL:150 PPM
ACGIH TLV:150 PPM; 9192
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:ISOBUTYL ISOBUTYRATE
CAS:97-85-8
RTECS #:NQ5250000
Fraction by Wt: 1-5%
ACGIH TLV:100 PPM

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:EYES: SEVERE IRRITATION, REDNESS,
    TEARING; BLURRED VISION. SKIN: IRRITATION, DEFATTING, DERMATITIS.
    INHALATION: RESPIRATORY IRRITATION, DIZZINESS, WEAKNESS, FATIGUE,
    NAUSEA, HEADACHE, UNCONSCIOUSNESS  & EVEN ASPHYXIATION. INGESTION:
    GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING & DIARRHEA.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INGESTION: ASPIRATION INTO THE LUNGS CAN CAUSE
    CHEMICAL PNEUMONITIS WHICH CAN BE FATAL. SKIN: PROLONGED OR
    REPEATED CONTACT CAN CAUSE MODERATE IRRITATION, DEFATTING,
    DERMATITIS. INHALATION: PROLONGED/ REPEATED OVEREXPOSURE RESULTING
    IN LIVER ABNORMALITIES, ANEMIA, KIDNEY/EYE/CNS DAMAGE, CARDIAC
    ABNORMALITIES.

=======================  First Aid Measures  =======================

First Aid:EYES: FLUSH W/LARGE AMOUNTS OF WATER. SKIN: WASH W/SOAP &
    WATER. INGESTION: DON'T INDUCE VOMITING. KEEP PERSON WARM, QUIET.
    INHALATION: MOVE TO FRESH AIR. IF BREATHING IS DIFFICULT,
    ADMINISTER OXYGEN.	IF BREATHING HAS STOPPED, GIVE ARTIFICIAL
    RESPIRATION. GET MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:-4F
Lower Limits:1.0%
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER FOG
Fire Fighting Procedures:USE SCBA W/FULL FACEPIECE OPERATED IN PRESSURE
    DEMAND OR OTHER POSITIVE PRESSURE MODE. USE WATER FOR COOLING
    MATERIAL STORED IN VICINITY OF FIRE.
Unusual Fire/Explosion Hazard:VAPORS ARE >AIR/MAY TRAVEL ALONG THE
    GROUND TO AN IGNITION SOURCE. RESIDUAL SOLVENT VAPOR IN EMPTY
    CONTAINER MAY EXPLODE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ABSORB LIQUID W/RAGS, FLOOR ABSORBENT,
    VERMICULITE OR OTHER ABSORBENT MATERIAL/TRANSFER TO HOOD. ELIMINATE
    ALL IGNITION SOURCES-DIKE AREA OF SPILL TO PREVENT
    SPREADING-VENTILATE AREA IF INDOORS-PUMP L IQUID IN TO SALVAGE
    TANK/PREVENT RUN-OFF TO SEWERS

======================	Handling and Storage  ======================

Handling and Storage Precautions:DON'T STORE NEAR HEAT OR OPEN FLAME.
    CHECK CONTAINERS FOR LEAKAGE CAUSED BY MISHANDLING. NEVER USE
    CUTTING TORCH ON EMPTY CONTAINERS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV IS EXCEEDED, NIOSH/MSHA JOINTLY APPROVED
    AIR SUPPLIED RESPIRATOR IS ADVISED IN ABSENCE OF PROPER
    ENVIRONMENTAL CONTROL. ENGINEERING OR ADMINISTRATIVE CONTROLS
    SHOULD BE IMPLEMENTED TO REDUCE EX POSURE.
Ventilation:PROVIDE SUFFICIENT MECHANICAL/LOCAL EXHAUST VENTILATION TO
    KEEP AIR
Evaporation Rate & Reference:(N-BU AC = 1): 3.29
Appearance and Odor:COLORLESS TO SLIGHTLY AMBER LIQUID.
Percent Volatiles by Volume:100%

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING, REDUCING AGENTS
Stability Condition to Avoid:IGNITION SOURCES, PILOT LIGHTS, SMOKING,
    HEATERS, ELECTRIC MOTORS, SPARKS, ELECTRICAL SWITCHES, STATIC
    DISCHARGES/FLAME
Hazardous Decomposition Products:CO, CO2, VARIOUS HYDROCARBONS

====================  Disposal Considerations  ====================

Waste Disposal Methods:ALLOW VOLATILE PORTION TO EVAPORATE IN HOOD.
    DISPOSE OF REMAINING MATERIAL IN ACCORDANCE W/APPLICABLE
    REGULATIONS. DESTROY BY LIQUID INCINERATION CONTAMINATED ABSORBENT
    MAY BE DEPOSITED IN LANDFILL IN  ACCORDANCE W/LOCAL, STATE &
    FEDERAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.